BOB UPTON, Realtor®, CBR's Blog
Paint is the magic elixir when it comes to inexpensive home makeovers. It rejuvenates space in a way few other things can do. Yet many homeowners have blinders on when it comes to the places they can paint. Namely, they only see the walls as a palette. Let's challenge that notion and remind you of a new way to use paint -- on cabinets.
Step One: Prepping
Whatever you do, don't skip step one — prepping. Though tempting to overlook, the risks of ruining your cabinetry if you do are simply too high.
To prep your cabinets, begin by labeling each cabinet opening and door front with corresponding numbers marked on painter's tape. This will save you countless headaches when it comes time to reinstall. You'll remove the labels before spraying with primer and paint, and then replace the tape when you're ready for reinstallation. You can place the labels just above wherever you've set the pieces to dry so you don't lose track.
Remove all hardware, including hinges and screws. If you're getting new hardware, it likely won't align properly, so be prepared to redo these holes later.
Wipe each cabinet front with a bonding solvent. Allow 1 1/2 hours of drying time before troweling a thin layer of spackling compound over the entire surface to fill holes, blemishes and wood grain pores. Use a second coat if deep holes are evident.
Next, it's time to sand. Doing so eliminates any existing sheen or protective sealant from your cabinets, thereby allowing primer and paint to bond appropriately to the surface. Fine-grit sanding blocks or pads work best for most cabinet and drawer fronts; however, rough-grit sandpaper is acceptable for cabinets with a lot of lacquer or shellac.
Step Two: Add Primer
After vacuuming or wiping down the cabinets, add primer using pigmented shellac sealer and a 2-inch brush. Pour about 1 1/2- inches of your primer into a small can and dip the brush about 1-inch. Press the brush against the side of the can to remove excess primer. Don’t wipe it across the rim, as this removes too much primer. Shellac dries quickly, so move fast and avoid going back over areas that have started to dry. Try to avoid heavy buildup and runs, but don't be overly concerned with uneven patches.
Step Three: Paint
Brush on the first coat of paint, then smooth it out with just the tip of the brush. Follow each layer by sanding lightly using a fine-grit sanding sponge.Allow at least 8 hours for each layer to dry before going over it again. Work from top to bottom to avoid dripping on finished areas. Likewise, paint the insides of the cabinets before moving to the outside. If any paint spills onto a finished area, simply dab it with a cloth dampened with mineral spirits.
Step Four: Reinstall Hardware
Finally, it's time to reinstall door hinges, handles, pulls, mounting plates, and other hardware removed for the project. Once this is complete, attach the door fronts and reset the cabinets in place.
Getting ready for a move or remodel can be stressful. Call, email or use the contact form on the site to schedule a consultation today.
You may be surprised to learn just how much a little DIY storage bench in your entryway can save you in time and money. Storage benches offer children a place to sit while they remove snowy or muddy shoes. That's less time spent mopping your kitchen or steam-cleaning the carpets.
Save hardwoods from years of damage and wear.
On top of that, a bench can double as storage. Never again will you be racing around your home trying to find your mittens, scarves, rain boots and other outdoor essentials on your way out the door. It's now all in one convenient place.
You can even store backpacks and lunch bags on the weekend -- whatever makes sense for your family.
You might think that making an entryway storage bench is complicated. But we'll show you the easy way to build your bench in less than a day.
What you'll need
*Pro tip* Borrow tools that you may never use again before buying. If you find you want to take on more new projects, you can buy one then.
How to build a DIY storage bench for your entryway
Here's your guide.
Gather materials & supplies
The amount of material varies by the bench size you choose the make. Be sure to measure twice and cut once so that everything fits perfectly.
Frame your bench
Your frame becomes your guide for the project. Cut your 2X4's the desired length of the bench. Then cut more for the height. Find the studs. And use that hammer drill to attach the 2X4s to the back wall. Build out from there.
Construct the front and sides
Now build around your frame, using your plywood. Be careful with any tools you use. Just take your time to get it right.
Add the hinges
Measure and drill for your hinges. Then simply screw them in.
Place the lid on the ground and drill holes for hinge screws. Then connect the top to the other side of the hinge with screws. You might need a partner hold the lid steady while you to screw in the lid.
Add your finish of choice
You can stop with a basic box. But while you're at it, it won't take much more effort to add some trim and paint it. Then place some hooks above for coats and backpacks.
And now, you have a beautiful DIY storage bench. For more helpful tips on home maintenance and improvement, follow our blog.
Everyone has experienced that overflowing, chaotic closet. Clothes everywhere and you can't find what you're looking for. For some, this occurs occasionally, but for others, especially those with smaller closets, this can be a constant stressor that effects your time getting ready in the morning and your mental stress when trying to get where you're going. Not everyone can afford a fancy closet system that easily helps organize your clothes, and some simply don't have the space to implement one. So, what can you do to help yourself organize your clothing without installing a system? Here are a few simple organization methods to consider.
Organize by like colors.
If you pair your outfits by matching colors, it can help to organize your clothing by color. Arrange black with black, blue with blue and so on. It can further help to hang your clothes to organize by color and in a sort of gradient pattern. Start with black, then grey, then white, then yellow, green, blue, purple pink, brown, patterns, etc. You get the idea. When you look in your closet each morning, you can head directly for the color you want to wear that day and easily find the clothes to match.
Organize by like items.
Hanging your clothing by like items is another simple way to organize. Hang jeans, pants, skirts then dresses together. Then, hang shirts together and separate by type: tank-tops, t-shirts, long sleeves, button downs, sweaters, sweatshirts, jackets. When you go to get ready, you'll be able to easily see the different pieces you need to complete your outfit.
Organize by purpose.
If you wear specific clothing for work that you don’t wear outside of work, it can be beneficial to organize your clothing by purpose. Put all your work-wear together and all your casual wear together. Place workout clothes together and all your dress clothes together.
Organize by frequency worn.
One more idea, particularly useful for narrow closets is to separate your clothes by the frequency that you wear them. Put the clothing you wear most toward the front of your closet and the clothes you wear least toward the back. Depending on the season you might consider moving your winter or summer clothing to the back of your closet until the appropriate time.
By implementing any one or a combination of the methods above you'll be well on your way to staying organized, saving time and reducing morning stress. If you have a lot of clothing and will be moving to a new home soon make sure that a large closet with a built-in organization system is on your checklist of required home features. Your professional real estate agent will help you find the best home for your wardrobe.